Set of hydraulic flanges for Vivoil motor
Product information "Set of hydraulic flanges for Vivoil motor"
Set of hydraulic flanges for Vivoil motor
The set of hydraulic flanges consists of a flange for the pressure side with a 1/2" female thread and a flange for the return side with a 3/4" female thread.
The flanges are screwed onto the motor of the Cuatmaster Basic. Following that, your hydraulic hoses are connected to the flanges.
Accessory Items
Grapple saw Cutmaster Basic
€1,444.57*
Grapple saw Cutmaster Basic
The grapple saw may be attached to different grippers on excavators, cranes or front loaders. For this purpose, three different sizes are available.
The saw as well as the lubrication oil tank are mounted in the blade protection which can be attached to your gripper via oblong holes.
The size of the sword protection is adjusted to the length of your blade. Should you wish to mount a longer sword, this is possible. The blade then protrudes from the front of the protection.
The saw is equipped with a powerful 9.3 kW hydraulic motor which drives the chain to a cutting speed of 20.3 metres/s. At full speed the motor requires 31.5 litres of hydraulic oil per minute.
Upon request also available with other engine sizes.
6 KW (21 litres/min)9.3 KW (31.5 litres/min)14.4 KW (50.4 litres/min)Available blade lengths:54cm64cm75cmThe insert length is the sword length - 10cm
Scope of Supply:
- Cutmaster Basic (with the chosen motor size)
- Blade protection adjusted to the chosen blade length
- 1 blade
- 1 chain
Cutmaster Basic
€1,350.00*
Hydraulically driven chainsaw
The Cutmaster Basichas been specially developed for use in cutting devices and firewood harvesters.
The saw can be supplied with various sizes of powerful hydyraulic motors which drive the chain with a cutting speed of 20m/s.
Due to the large selection of sword lengths (54cm to113cm) the Cutmaster Basic can be used very variably. The chain is tensioned by a set screw and lubricated by the integrated lubrication system.
The Cutmaster Basic is equipped with a hdraulic swivel system..
- Integrated chain lubrication- 20 metres/sec cutting speed- chain pitch 0.404".- chain wheel with 14 dents- left-hand and right-hand design- hydraulic swivel device- swivel axis in the motor shaft- robust stainless steel construction
Variants from €1,100.00*