Cutmaster Speed

Product information "Cutmaster Speed"

Hydraulically driven chainsaw

The Cutmaster Speed has been specially developed for use in cutting devices and firewood harvesters.

The saw can be supplied with a powerful Parker axial piston motor, two sizes of which are available. This motor drives the chain with a cutting speed of up to 60 metres/s.

Motor size 6ccm: 50 KW – 67 litres/min (at 400bar)

Motor size 10ccm: 85 KW – 110 litres/min (at 400bar)

While the motors do not have to be driven with a 400 bar pump, please bear in mind that in case of a 200 bar pump, only half the capacity can be reached while the speed remains unchanged.

Due to the large selection of sword lengths (54cm to 135cm), the Cutmaster Speed can be used very variably. The chain is tensioned by a set screw and lubricated by the integrated lubrication system.

The Cutmaster Speed is equipped with a hdraulic swivel system.

- Integrated chain lubrication
- 40 metres/sec cutting speed
- chain pitch 0.404".
- chain wheel with 13 dents
- left-hand and right-hand design
- hyraulic swivel device
- swivel axis in the motor shaft
- robust stainless steel construction

- Axial piston motor with 10,000 rpm

- loadable up to 400bar

Zubehörartikel

Saw-bar

Saw-bar The saw swords are suitable for all our saws. With the Harvester pitch of 404, the necessary stability is achieved. The specified length is the total length, some 10 cm of which are needed for clamping in the saw. This means that e.g. the available lengh of a sword measuring 75 cm is approx. 65 cm.

From €87.23*

Details

Chain wheel sprockets

Chain wheel sprockets Available in various pitches Pitch 12, 13, 14, 15, 16 Pitfch 14 is the standard in our Cumaster Basic. Pitfch 14 is the standard in our Cumaster Speed. Pitfch 14 is the standard in our Cumaster Electro. The chain sprockets all have a pitch of 404 and a 25 mm borehole with featherkey notches.

From €48.18*

Details

Micro throttle valve

Micro throttle valve The micro throttle valve is perfectly suitable wherever precise control is required for small volume flows.The integrated non-return valve throttles the volume flow from 'A' to 'B', while there is free flow from 'B' to 'A'. Connections: G1/8" The throttle is used to adjust the swing speed of the saw.

€44.54*

Lubrication oil tank (direct assembly)

Lubrication oil tank for direct assembly The lubricating oil tank can be mounted directly on the Cutmaster Basic, Speed or Electric.The tank holds approx. 1 l of lubricating oil.

€85.00*

Pressure reducing valve

Pressure reducing valve Functionality Once the pressure in 'U' is reached, the valve blocks the passage between 'E' and 'U' to keep the pressure 'U' constant.If the pressure in 'U' is exceeded, it can be relieved via 'Dr'. This does not influence the upstream pressure in 'E'. Since it is a single-acting valve, it allows a free oil return from 'U' to 'E' Adjustment range from 5 to 50 bar. Connections: G3/8" The pressure reducing valve is used to adjust the pressure on the swing cylinder.

€183.87*

Welding holder Cutmaster Speed

Welding holder for the Cutmaster Speed The holder is suitable for firewood harvesters or cutting units. It is simply welded onto your construction and then the saw can be mounted. The holder has got a thickness of 10 mm.

€55.00*